Friday, September 19, 2014
PIONEER DDJ ERGO V HOW TO ENTER SERVICE MODE HOW TO DO A FACTORY RESET
Service Mode Entry & Factory Reset procedure_Pioneer DDJ ERGO V _ DJ Controller
(1) How to Program for USB Controller copy mode
* While simultaneously holding the LOOP OUT and VINYL buttons on the Deck A/C side pressed, set the Power switch of the unit to ON.
* Data for the TUSB firmware in the MAIN_UCOM will be copied to the EEPROM.
* During copying, the FUNCTION LED is lit.(2) Firmware Update
* Set the Power switch to ON without pressing any other buttons.
* Data for all areas in the ROM, excluding those for the boot area, will be rewritten.
(3) Version of the Firmware Confirmation [with hardware alone]
* While simultaneously holding the DECK A and KEYLOCK buttons on the Deck A/C side pressed, set the Power switch of the unit to ON.
* The version number will be indicated with the LEDs on the controller, with no need for starting up any application.
(4) Service Mode
* While simultaneously holding the LOOP IN and F2 buttons on the Deck A/C side pressed, set the Power switch of the unit to ON.
* In this mode, you can check if each element on the controller can operate and each LED can light properly, with no need for starting up any application.
(5)JOG Load measurement modes.
* While simultaneously holding the F2 and F3 buttons on the Deck A/C side pressed, set the Power switch of the unit to ON.
* This mode is for judging if the load value for the JOG dial while it is being turned is OK.
(6)Point of sale demonstration modes.
Demonstrations with lighting of the LEDs (illumination) are automatically performed at shops even if no PC application is started.
This mode will be established if no reception via MIDI is performed for 1 minute after the controller is turned ON.
(7) Factory Reset (To return the settings to the factory default values)
* While simultaneously holding the DECK C and FX 1 buttons on the Deck A/C side pressed, set the Power switch of the unit to ON. The VINYL mode ON/OFF and Normal/Active mode are reset to the initial settings.
FACTORY RESET MODE [Details]
* To enter this mode, while simultaneously holding the DECK C and FX 1 buttons on the Deck A/C side pressed, set the Power switch of the unit to ON. (Hold the two buttons pressed until the opening display terminates.)
* During Factory Reset mode, the VINYL LEDs on both sides are lit.
* When you exit this mode, the LEDs go dark.
To check whether the initial settings are restored.
Checking VINYL ON/OFF
* After the unit is turned on and the opening illumination is finished, if the VINYL LED is lit, it is set to ON (OK).
Checking of Normal/Active Mode
Check the following, after starting the application on the connected PC.
* Load a piece of music onto any of the decks (Deck A, B, C, or D).
* Check that blue LEDs on the JOG dial are lit (Active mode)
Checking Method with the Controller Alone.
* Establish Version Confirmation mode, by turning the unit ON while simultaneously holding the DECK A and KEY-LOCK buttons on the A/C deck side pressed.
Checking VINYL ON/OFF
Check the same as described.
Checking of Normal/Active Mode
Check that blue LEDs on the JOG dial are lit (Active mode). (LED indication is the same as described)
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment