Wiring & diagram Info: 3

Showing posts with label 3. Show all posts

Thursday, November 20, 2014

3 Channel Audio Mixer Circuit

Although the modular Portable Mixer architecture accessible on these web pages has become a hit for abounding amateurs, some correspondents appropriate a abundant simpler device, mainly for bond address signals.

This architecture should fulfil their needs, featuring three inputs with switchable high/low acuteness and abnormal level-control circuits, accouterment aerial afflict margins and low-noise figures, proportional to gain-level settings. Low accepted burning due to a simple, five-transistor circuitry, allows the Mini Mixer to be powered by a accepted 9V PP3 array for abounding hours.

Sunday, September 21, 2014

Fuse Box Diagram Of 2008 Mazda 3

The following circuit shows about Fuse Box Diagram Of 2008 Mazda 3. The parts fuse panel consist of: Audio system , Power Control Module, Fuel pump, Power outlet, Interior lights, O2 sensors.Front fog lights, Horn, Daytime Running Light, Blower motor , Headlights, ABS, DSC, For protection of various circuits, Cooling fan, Power steering, Fuel pump, Power steering, Air conditioner, Ignition switch, Starter clutch, Ignition switch , Cooling fan, Power steering, Rear window defroster, Injector, For protection of various circuits.

Sunday, September 7, 2014

Alcohol Gas Sensor MQ 3

Alcohol Gas Sensor MQ-3 is an alcohol sensor is suitable for detecting levels of alcohol directly, for example on our breath.

Alcohol Sensor MQ-3 has high sensitivity and fast response time. Alcohol Sensor MQ-3 series drivers for alcohol Sensor MQ-3 is very simple, only need 1 piece of variable resistors. Output of Sensor MQ-3 alcohol in the form of an analog voltage that is proportional to the alcohol content is received. The necessary interface is quite simple, can use the ADC that can respond to voltage 0 volt - 3.3 volt saja.Nilai mounted resistors must be differentiated for various types of gas concentration. So need to be calibrated to 0.4 mg / L (about 200ppm) concentrations of alcohol in the air and on the output resistance of about 200K (100K to 470K)

Alcohol Gas Sensor MQ-3

Featured Alcohol Gas Sensor MQ-3:

Sensitivity to high alcohol and low on gasoline
Fast response and high sensitivity
Stable and durable
5VDC or AC voltage source
Operating Temperature -10 70 degree C samapai
Current consumption less than 750mW

Saturday, September 6, 2014

3 Channels Audio Splitter Amplifier Wiring diagram Schematic using TL084

This is the schematic diagram of 3 channels audio splitter amplifier schema which built using op-amp IC TL084. The 3 channels amplifier output distribution applies a single TL084.

3 Channels Audio Splitter Amplifier Circuit Diagram

The very first step is to capacitive coupling having a p. 1.0 ~ electrolytic capacitor. The entries are railways Vee Y2 or 4.5 V. This enables working with an individual 9V power source. A voltage gain of 10 (1 M?/100 Kohm) is obtained in the first stage, as well as the other three floors are connected as a unity gain voltage followers. Every single output stage drives independently through an amplifier output 50 pF capacitor towards the resistance of 5.1 k ohm load. The response range is flat from 10 Hz to 30 kHz.