Wiring & diagram Info

And place it in workspace.

 

As same as add a Diode(shortcut key “d”), Capacitor(shortcut key “c”),and Ground(shortcut key “0”) symbol one after one in the same way and place in workspace(see below). To rotate  any device click on device and press “ALT+R”once or two times or as needed.

 

To see the circuit in zoom view press F2 . Then you see “Circuit Scale” window, enter a value between 10 to 2000 % that you want to scale (I’m entered 150%). And press “ENTER”.

Now the circuit symbol will larger, now we can design the circuit in circuitmaker 5 easily.

Back to adding schematic symbol.

Now add two “Terminal” (see below...)

Do that two times and then rotate as shown below.

Select the “Wire tool” (see below…) 

To connect two pins of two device click to pin(1) and drag until to pin(2). See below…

 

Connect all the pins that are necessary (see Fig:1).

After connect the circuit its looks something like this…

 

Don’t worry, this is a simple task. But simulation is necessary for a circuit. To determine that it have any error or it giving us the expected output or not.

Before simulate the circuit we have to confirm that the simulation mode is Analog. To select Analog mode click once on “Digital/Analog” button from toolbar. And then the icon will change. See below...

  

If a confirmation massages box come then select “Yes”.

Then you will see the simulation window. See below...

 

Note: If you want to change any parts/device/source value in the circuit, double click on the parts/device/source and enter your value.